Hi all,
Just a simple multilevel Hexagonal Key tidy.
There are 3 heights of key fob to match the varying heights of the holder. Below are the quantities of each you would need to print to fill the holder but I think it looks better if you leave some gaps
x4 – 15
x11 – 20
x4 – 25
Depending on your printer you may need to scale the print to fit on your bed.
Technically there should be a 0.1mm gap between the fob and the holder but I had a slight issue with the squish effecting the fit of the fobs into the holder so I scaled the fobs slightly more than the holder.
I scaled to;
Holder = 70%
Fobs = 68.5%
Just because I preferred the smaller fob size for the keyrings.
Update:
I have added a v2 holder to fit the 15mm key fobs. That way you can print all 15’s.
I have also added a v2 with holes as i know someone mentioned mounting it on a wall.
Cheers
screenshot-www.thingiverse.com-2022.03.16-11_39_00-0a9d1352
screenshot-www.thingiverse.com-2022.03.16-11_39_32-5e587961
screenshot-www.thingiverse.com-2022.03.16-11_39_45-124c7249- https://www.thingiverse.com/thing:4775253
- mpgreenough1986
- Design2v2_-_with_holes-d72a61ac
Design2v2_-_with_holes-d72a61ac -
This content is licensed under a Creative Commons Attribution 4.0 International license.