This holder can allocate 8 wide USB sticks, 8 SD cards, and up to 15 MicroSD cards.

Ideal for your desk, to keep your portable storage in a single place when you need them.

It has holes to prevent from dust accumulation, and reduce a little the material used to print it.

* This design is an improvement to USB and SD card holder for wide USB sticks; now including better holding for MicroSD at 60 degrees (almost vertical), while extending space for up to 15 (instead of only 5), and fixed some vector errors.

Print Settings

Printer:

RepRap Mendelmax

Rafts:

No

Supports:

No

Resolution:

0.3 mm

Infill:

10%

Notes:

Printing doesn’t need any special adjustment, just print it and enjoy!

Even though it has an upside angle (+60º), shouldn’t need any support.

Post-Printing
Recommendation

Attach a foamy, or rubbered sheet on the base so it doesn’t slip while in your desk, but remember to maintain holes clear.