This is a customization of an original model by JAYTEEAU. His design worked great but I didnt have a area to screw this part flat. So I made a closed end so it can be hung on the right wall. I print this at 200mm/s on my ender 3 with 10% infill. Takes about 19 hours. I use 1 1/4 inch wood screws. I was concerned about the screw head grabbing the bags. with 3 a 3 layer wall you can squish the PLA so the wood screw will be flush to the inside of the cylinder and not grab the bags. I have linked JAYTEEAU’s orginal file below. Happy printing.
screenshot-www.thingiverse.com-2022.04.11-18_33_19-f2b3ff10
screenshot-www.thingiverse.com-2022.04.11-18_33_30-3db26d14- https://www.thingiverse.com/thing:4704538
- Darksole03
- Trash_Bag_Dispencer_Right_wall-7b222c04
Trash_Bag_Dispencer_Right_wall-7b222c04 -
This content is licensed under a Creative Commons Attribution-NonCommercial 4.0 International license.
0
0
votes
Article Rating
Subscribe
Login
Please login to comment
0 Comments
Inline Feedbacks
View all comments