Stanford Bunny

Stanford Bunny model for all those who are bunny lovers.

Collapsing Single Piece Lightsaber

This is a collapsing Lightsaber designed to be printed as one part. Its only 205mm high when printed but expands to over 950mm in total length! It also makes a really cool noise as it expands as a result of the layer lines rubbing together which really takes people off guard.

The Lightsaber is designed to be printed with a ,4mm nozzle, so the blade will be two shells thick.

This print was printed on Anycubic Vyper


This is a simple calibration test cube for your 3D printer with X, Y & Z written on the axis.

To further calibrate your 3D printer print one out and you can then measure this models dimensions against the expected dimensions.

Once this is done you are able, if your 3D printer allows it, to adjust your Steps per mm in your printers firmware.


This is the original test print model of the owl.



This is the Original Benchy Print Model